Indoor Swimming Pool HVAC Design: Evaporation, Dehumidification and Heating

Indoor Swimming Pools

Indoor Swimming Pool HVAC Design: Evaporation, Dehumidification and Heating

An indoor swimming pool evaporates water every hour of the day. Here is how to calculate that moisture load, and how dehumidification, ventilation and swimming pool water heating fit together in one design.

Applied Engineering Team
Oct 18, 2026
14 min read

Introduction to Indoor Swimming Pool Design

An indoor swimming pool hall is one of the hardest spaces a mechanical engineer can design. The water surface?evaporates continuously, so moisture is added to the air every hour of the day and night.

If that moisture isn't controlled, the consequences are expensive: condensation on windows and cold walls,?corrosion of steel and fixings, mould inside the structure, poor air quality, and uncomfortable swimmers and?spectators.

Why indoor swimming pools are difficult

  • The moisture load is large and continuous, and it changes with activity.
  • Air and water temperatures are high, so the room dew point is high.
  • Swimming pool chemistry releases chloramines, which harm air quality and attack materials.
  • Large glazed areas create cold surfaces where condensation forms.


Calculating evaporation
Evaporation depends on four things: the water surface area, the difference between the vapour pressure at the?water surface and in the room air, the air velocity over the water, and how actively the swimming pool is used.
The ASHRAE Handbook - HVAC Applications (natatoriums section) gives an empirical equation for the?evaporation rate:
W = (A / Y) - (pw - pa) - (0.089 + 0.0782 V) - Fa
  • W: evaporation rate, kg/s
  • A: swimming pool water surface area, m?
  • Y: latent heat of vaporization at the water surface temperature, kJ/kg
  • pw: saturation vapour pressure at the water surface temperature, kPa
  • pa: partial vapour pressure of the room air (at its dew point), kPa
  • V: air velocity over the water surface, m/s
  • Fa: activity factor (table below)
  • Residential swimming pool: 0.5
  • Condominium: 0.65
  • Therapy: 0.65
  • Hotel: 0.8
  • Public and school: 1.0
  • Whirlpools and spas: 1.0
  • Wave swimming pools and water slides: 1.5 (minimum)
Because evaporation depends on activity, a public swimming pool with a wave machine needs about three times?the dehumidification of a residential swimming pool with the same area and temperatures.


Design conditions
  • Competition swimming: 24-28?C
  • Recreational: 24-29?C
  • Diving: 27-32?C
  • Therapy: 29-35?C
  • Whirlpool and spa: 36-40?C
For the main swimming pool hall, room air is normally kept 1-2?C above the water temperature, at 50-60%?relative humidity. Warmer, moderately humid air reduces the vapour pressure difference and therefore?evaporation, and keeps wet swimmers comfortable. Air colder than the water increases evaporation sharply.


Ventilation and air quality
  • Outdoor air: ASHRAE 62.1 requires 2.4 L/s per m? of swimming pool and deck area, with spectator areas?calculated separately.
  • Exhaust: extract air where chloramines collect, close to the water surface and away from supply air paths.
  • Pressure: keep the swimming pool hall at a slight negative pressure relative to changing rooms and adjacent?spaces, so humid, chlorinated air doesn't migrate.


Dehumidification options
  • Outdoor air: Bring in drier outdoor air and exhaust humid room air, with heat recovery to limit energy use.?Works well where outdoor dew points are low; poorly in hot, humid climates.
  • Mechanical (heat pump): Cool the air below its dew point so moisture condenses on a coil, then reuse the?condenser heat to reheat the air and/or heat the swimming pool water. Moisture removal doesn't depend on?the weather.
  • Hybrid: Combine both: outdoor air when conditions allow, mechanical dehumidification when they don't.
In coastal Gulf cities, outdoor dew points stay high for much of the year, so mechanical dehumidification is?usually required.


Condensation and the building envelope
Condensation forms on any surface colder than the room dew point. At 30?C and 55% relative humidity the dew?point is about 20?C, so glazing, frames and exterior walls are at risk whenever it's cold outside.
  • Supply warm, dry air across glazing and along exterior walls.
  • Check the inside surface temperature of glazing and thermal bridges against the room dew point at the winter?design condition.
  • Install a continuous vapour retarder on the warm side of the envelope.


Swimming pool water heating
The swimming pool water loses heat through:
  • Evaporation, usually the largest loss
  • Convection to the room air
  • Radiation to cooler surfaces
  • Conduction to the ground and structure
  • Make-up water that replaces evaporation, backwash and splash losses
Covering the swimming pool when it isn't in use cuts evaporation, and with it both the water heating load and?the dehumidification load during unoccupied hours.

What swimming pool design software should do
Select the optimum unit components for a comfortable swimming pool room environment: the right dry-bulb?temperature, wet-bulb temperature and relative humidity, with a suitable swimming pool water temperature.


Common mistakes
  • Designing for one condition only, without checking unoccupied hours or peak activity.
  • Keeping the air colder than the water.
  • Ignoring spectator areas and their extra outdoor air and latent load.
  • Poor air distribution that leaves glazing without dry air.
  • No swimming pool cover strategy for unoccupied hours.


Our swimming pool design software
We've built new software for indoor swimming pool design, around the design steps in this article. Book a demo?to see it on your next swimming pool project.


Key takeaways
  • Evaporation drives the design; it depends on area, vapour pressure difference, air velocity and activity.
  • Keep room air 1?2?C above the water, at 50?60% relative humidity.
  • In humid climates, mechanical dehumidification with heat recovery is usually required.
  • Calculate dehumidification, ventilation, condensation and water heating together

More Articles